Attic vent screen insert with replaceable mesh
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This part offers protection from unwanted parties entering the attic space, without compromising air-flow.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 152
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this part as the existing system was to put a mesh sheet behind a wood plank with holes cut through it. Unfortunately, some of the screens became damaged. I designed this piece so that it will go into the holes and offer the ability for the mesh screen to be easily replaced.
I recommend printing with PETG, it should be better suited for outdoor use and it is harder than PLA. Also, as the part has threads a layer height of 0.15 mm is preferable due to the overhangs.
Current dimensions for the wall insert are diameter 53 mm, depth 20 mm.
I bought some mesh screen sheets and used some snips to cut out a circular mesh screen. approx. 50 mm diameter.
There are two lock washers that allow for the installation of a single mesh screen or you can double it up.
I bought some mesh screen sheets and used some snips to cut out a circular mesh screen. approx. 50 mm diameter.
If you have a slanted roof might be better to mount it at 45 degrees off axis so you can get the drill in. I also recommend predrilling holes for installing the screws.
The top cover screws in last to hide the screw holes, giving a better aesthetic.
I also recommend using some lubricant/grease on the threads for easier installation.
You will need to buy:
Screws:
Mesh screen:
Wire Mesh Sheet, 4 Pack 16 Mesh... https://www.amazon.com/dp/B0CH7XHF7J?ref=ppx_pop_mob_ap_share
Tools:
I recommend using some snips. These ones worked well for me: