Jabra monaural headset pad
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A pad for the end of that mono headset band. The original had been shattered, needed to replace it.
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 79
- Wydruki
- 0
- Wyświetlenia
- 208
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
That's the pad for the “other” ear side on the Jabra Pro 94xx series, monaural headsets. It may fit any other such set, of course. As long as the metal band is about 4.5mm x 0.9mm cross section.
Note that the design has a pocket inside the main “pad” body, so that the metal band goes all that far in and prevents it breaking at the “T” junction.
I had to squeeze these end latches to make it slide in, it's a tight fit. Advice is to lock the metal band with pliers and then squeeze the plastic on it by grabbing+holding it throughout the body (not just push it from the end).
Printing wise, it came out easy: 20% infill, PLA, print upwards with a brim and no supports.