Qidi X Plus 3 BIQU micro probe adapter

for the BIQU micro probe V2.  direct replacement of existing hall sensor,  using V2 hotend, so may need to adjust model thickness accordingly.  Never measured stock hotend vs. the V2 hotends i assume the are similar.  

ADDITIONAL CONFIG INFO

the following instructions is what i went off of for the config, though my mount is not the same one as this user.

2pin Socket:
- Left = Ground (Black of 2pin plug)
- Right = Sensor (White of 2pin plug)

3pin Socket:
- Left = 5v (Red of 3pin plug)
- Middle = Ground (Black of 3pin plug)
- Right = Servo (Yellow of 3pin plug)

Important: You need to swap the Black and Red of the 3pin plug on the microprobe over.

Needs modifications to the printer.cfg file. Please see below for guidance (I have re-wrote and split my config up)

Config information is located here:
https://github.com/SmileyMan/Qidi-X-Smart-3-Klipper-Config

My probe config (I have renamed Tool-head Board from MKS_THR to Toolhead):
https://github.com/SmileyMan/Qidi-X-Smart-3-Klipper-Config/blob/main/sub_config/probe.cfg

[[[[[ His model had the probe mounting on the left hand of the hotend this is just addtional configuration due to that change ]]]]]]]]]]]]]

“”"My bed config:
https://github.com/SmileyMan/Qidi-X-Smart-3-Klipper-Config/blob/main/sub_config/bed.cfg

My homing override code - This ensures Y is homed first and backed off 15mm so micro probe is not pushed against the printer frame:
https://github.com/SmileyMan/Qidi-X-Smart-3-Klipper-Config/blob/main/sub_config/homing.cfg “”"""""