1 / 9
Christmas Tree Ornament Print in Place Remix — zdjęcie 1
1 / 9

Christmas Tree Ornament Print in Place Remix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix of my fridge magnet cosplay prop. I thought it would also make a neat ornament.

Ocena
5 / 5
Polubienia
27
Pobrania
85
Wydruki
1
Wyświetlenia
905
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Share Alike

This is a REMIX of my interpretation of the Sticky bomb that is fired from the fictional story The Defender written by Larissa Soehn.

This Version adds a string holder so it can be used as an ornament.

The book The Defender, by Larissa Soehn can be purchased from Amazon.ca https://www.amazon.ca/dp/0228866030/ref=cm_sw_em_r_mt_dp_C45MY5Y5MX8X238XASPZ

In the book Alexia is plunged into an Alien world where she is forced to test her abilities immediately upon arrival to determine her "Threat Level". During of these tests she is given a two triggered bomb launcher that fires a 6 legged sticky bomb and then detonates it.

I wanted to design a Print in Place model for this design that is loosely modelled off the Octopus designs that you see floating around the internet.I figured it would also be cool to make it a fridge magnet to capture the "stickiness" mentioned in the book.

The Model fits 2 different sizes of magnets if you want, but really you can get away with the smaller of the 2 since they fit into each leg and allow you to pose the model on a metal surface.

The magnets I used were

6mm diameter x 3mm high for the leg magnets

12mm diameter x 2mm high for the central magnet.

Purchased from amazon.ca

https://www.amazon.ca/dp/B07WCN5FGD/ref=cm_sw_em_r_mt_dp_TF0S2ZFMG0P5DV7BF5M9?_encoding=UTF8&psc=1

and

https://www.amazon.ca/dp/B07GX7Z4DF/ref=cm_sw_em_r_mt_dp_ZT22HT5TT46R086EKF5Q?_encoding=UTF8&psc=1

 

Print in place, Pop off Bed
I added the various pieces and spikes in order to prevent needed a raft or Brim. It should be able to be printed right onto the bed. I have had plenty of success and I wish you all the best (every printer is a bit different but I was getting repeatable results with this design and my printer.

 

The original took me 8 attempts to get the legs right. The very first time I printed it off too small, then I worked on getting the right range of Motion, then I worked on ensuring I could get repeatable results without any Brim.

I created a bit of a Dome of the design so you could put anything into it.

 

 

Tagi