CASA Enclosure Rear Bay Mod

A simple modification to add a rear bay section to CASA. Features an interface plate to pass through air and coolant lines into the main area of CASA, flanges to capture the upper and lower panels and open area for MILO cables. Holes are 8mm and 10mm. Depth of the bay is 200mm.

A utility tray is included in the files which allows easy placement of things into the bay simply use zip ties to attach.

You will need to add two additional 340 mm long 2020 V slot extrusions at the rear locations as shown in the pictures. The rails should be mounted flush at the front and rear of the extrusions.

If needed you can use these corner brackets to mount your rear vertical extrusions. https://www.printables.com/model/743221-2020-extrusion-corner-bracket they worked very well.

Rear Bay Mod compatible with CASA Enclosure Flex Plate System so you can add things like air pressure regulator, pass through for air hose, mist, coolant, etc. the flex plate system can be found here. https://www.printables.com/model/920212-casa-enclosure-flex-plate-system

Width is the same as the front bay so you can also use any of the trays in the CASA Enclosure Storage Tray System. https://www.printables.com/model/910724-casa-enclosure-storage-tray-system/comments

Print Settings:

Sliced with Semi Structural settings.

Print at 100% since I already accounted for shrinkage.

Hardware to Enclose the Bay:

Side Panel

Qty 1 - 190mm x 274mm Panel

Qty 1 - Rear Bay Interface Plate

Qty 3 - CASA Panel Clip D

Qty 6 - M3 x 10mm socket head screws 

Qty 6 - M3 drop in or hammer head nuts

Rear Panel

Qty 1 - 150mm x 338mm Panel

Qty 4 - CASA Panel Clip D

Qty 8 - M3 x 10mm socket head screws 

Qty 8 - M3 drop in or hammer head nuts

Enjoy!