CASA Enclosure Display Arm Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple way to attach a small swing arm mount for controlling Milo within CASA.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 27
- Wydruki
- 1
- Wyświetlenia
- 256
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Public Domain
A simple way to attach a small swing arm mount for controlling Milo within CASA.
Replaces one corner clip so you have a place to mount a swing arm. This mount has the recess for the panel so you do not need to modify your current setup.
Hole spacing for the M5's is 148mm on centers.
I used this mount from Amazon https://www.amazon.com/dp/B00XUARRLW?ref=ppx_yo2ov_dt_b_product_details&th=1
Hardware Needed:
Qty 9 - M3 x 10mm socket head screws
Qty 9 - M3 drop in or hammer head nuts
Qty 2 - M5 x 12mm socket or button head screws
Qty 2 - M5 washers
Qty 2 - M5 x 9.5mm het set inserts
Print Settings:
Sliced with Structural settings.
Print at 100% since I already accounted for shrinkage.
Assembly:
After printing the part out of ABS, insert the two M5 heat sets from the rear of the mount. Then attach to CASA using the M3 screws and nuts. You can leave a little loose if you need to place your panel into place then tighten to secure the mount.
Use M5 bolts to attach your display mount and enjoy!
You can also use this tablet mount if desired. https://www.printables.com/model/918435-tablet-mount-vesa-100-compatible