Ryobi Expand-It Heavy Duty Hanger Cap with Quick Release
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Expand-It series hanging cap that is easy to put on and easy to remove
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 326
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
Hanger: This hanger is a more robust one than others I have seen. Ones that print upright has the layer lines that is weaker at the hole and hanger hook. This one prints on the side putting the layer lines straight from top to bottom. The hanger hole is large enough for up to maybe 5/8" (16mm) hanger. Since all angles are 30 to 45 degrees, no supports are needed. The pole hole is slightly oblong to help compensate for sagging when the top section is printed. I printed it at 0.20 layer, 4 walls, 40% infill, PLA.
Plunger: The plunger rests in the side hole and fastened with a 4mm diameter X 6 or 8mm long screw. The screw hole it prethreaded. When inserting hanger onto the tool, push until it stops and turn until the plunger pops out. When taking off, push plunger in and twist or pull straight off. Print with 100% infill.
Post Processing: When I printed this there was some stringing around the hanger hole to clean up and some plastic down the length of the pole hole due to no support on the inside. I cleaned the pole hole by wrapping a piece of sandpaper on a wooden dowel and sanding the inside ridge. Bevel any sharp edge. It does fit snug on the pole. If you feel it is to tight increase the axis to change the diameter but not the total length or the plunger may not fit correctly otherwise you will need to drill the plunger hole larger to compensate.