Genie Garage Door Opener Sensor Visor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sun can prevent the garage door sensor from functioning, preventing the door from being closed. This slip-on visor…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 270
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
Sun can prevent the garage door sensor from functioning, preventing the door from being closed.
This slip-on visor casts a shadow over both the transmit and receive sensors, which allows the door to close (hopefully) reliably!
This visor is designed to fit over a Genie garage door opener sensor set (#35048R). The sensor housing is 23.95mm in diameter measured with calipers. This part is 24.1mm dia, and fits very well.
Recommended to print in PETG or ASA/ABS as its exposed to sun and summer heat.
Recommended to spray paint with any matte black. Gloss plastic (PETG, PLA) might still reflect sunlight into sensor.
Red LED: Transmitter side
Green LED: Receiver side
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.3mm
Infill:
100%
Filament: Polymaker PETG
White
Notes:
PETG has great bed adhesion, had no trouble printing two of these without brim or raft.
Measured the object sensor lens housing OD, and added 0.1mm. Fits well.
Category: Automotive