Elantra N MagSafe Mount - With N Logo
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a MagSafe mount for the Elantra N, meant to go in the space on the circle on the left side of the dashboard.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 781
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update: I have added an updated design with a smaller external diameter to allow for fitment with phones that have raised camera bumps. Phone like the iPhone 15 Pro and Pro max, etc. all have raised camera bumps, and the earlier versions had too large of a diameter. The updated design accommodates and rectifies that issue.
This is a MagSafe phone mount for the Dashboard circle on the Hyundai Elantra N. The file must be printed in PETG or ASA to prevent warping and UV damage when sitting in your hot car.
You should print with at minimum 6 perimeters and 4 top and bottom solid layers- though the more the better - and at least 30% infill.
The added walls and layers help prevent warping from heat. Smaller layer sizes like 0.16mm are preferred. Do not use supports.
You need to add a ‘pause-at-height’ at the layer just prior to the bridging on the MagSafe area, and then add the magnets in once the print has paused.
IMPORTANT: Ensure that you are orienting the magnets in the correct polarity. Before placing the magnets in the print, stick them to the MagSafe magnets on your phone, and see which orientation is proper. Whichever side “sticks” to your phone, place that side face down in the print. This will ensure that it is facing towards the front of the print once it is complete.
MagSafe magnets from Amazon - https://a.co/d/0h5LaVPn
The backing supports up to 1" wide double-sided tape, and I prefer gel tape, as it is easy to remove once done.