1 / 4

Becker BK9 TPU Sheath V5

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Informacje o modelu

Haven't had a chance to field test this one fully.

The retention on the bk9 could probably be improved, although i haven't had an issue with it yet.

I wanted to make it a slip-on but 95A isn't ridge enough to handle it. So it is full loop only

Designed to fit a normal size Bic lighter, there is a hole in the bottom of that slot to accommodate my 0.5" ferro rod if i take that instead.

Multitool/Flashlight clip slot is 9.5x8mm

Belt slot is 6.5cm tall and 3mm deep, was thickened from previous version.

Printed on it's flat side, without any supports and a brim on a Neptune 3 Max. 16Hr print

Layer Height is 0.28mm

Walls/top/bottom:2mm thick

Infil: 15%

Bed/Nozzle: 60c/230c