Dampener Spring+Base for robotic mower Gardena R40li, R70li, Flymo 1200R, Husqvarna 105
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the Base and spring for the shell of the above mentioned robotic mowers, since they are all the same with a…
- Ocena
- 4,5 / 5
- Polubienia
- 10
- Pobrania
- 73
- Wydruki
- 1
- Wyświetlenia
- 418
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
This is the Base and spring for the shell of the above mentioned robotic mowers, since they are all the same with a different shell. The original Rubber Part gets brittle and rusty over time. The replacment part is 8€ *4 plus shipping, which is about half of what i paid for the robot used.
Print Settings
Supports:
Yes
Resolution:
0.1
100%
Filament: Any PLA, ABS, ASA.
Notes:
Printing the Coil needs 100% infill or, just a lot of walls and requires Supports within the model. Pay special attention no supports are generated in the middle of the model since that makes removing the supports very hard.
I used a 3mm diameter Wood screw with a flat head to fasten the part to the robot.
Category: DIY