1 / 1
PodPusi Negotiator for xBloom Studio Pods (unofficial) — zdjęcie 1

PodPusi Negotiator for xBloom Studio Pods (unofficial)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a Pusi Negotiator variant for wave filters to be used on the xBloom Studio xPods

Ocena
0 / 5
Polubienia
12
Pobrania
105
Wydruki
0
Wyświetlenia
875
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is an xPod variant of the Pusi Negotiator.

An unofficially designed negotiator for wave filters to be used with the xBloom Studio xPods. Thanks to EAF member @wonderllama for the dimensions of the xPods.

Brewing note: I recommend either this recipe designed by @pradyboy for Moodtrap beans, for use with this negotiator: 

Grind size: 67 @60rpm - https://share-h5.xbloom.com/?id=H0ziqjcH5%2BHAL7qcz0dpWA%3D%3D

Or my cold bloom version of Prady's recipe: https://share-h5.xbloom.com/?id=U4AIyiUZexus9wSI%2FyDHqg%3D%3D

Note on nomenclature: Pusi (푸시) is the Korean word for PUSH. Thanks to EAF member @heytchap for the name.

Printing tips:

  • Use the STEP file if you can instead of the STL (more reliable for slicing, but both included for convenience).
  • There are some chamfers so its best to use low layer height 0.16mm or lower for visuals, but go nuts with layer height if you don't care about looks. 
  • Recommend PETG if you use hot water to rinse filters, otherwise PLA/PLA+ is fine.
  • Extra walls and higher infill recommended (but not needed) to give a more solid feel to the shaft / handle.
  • You may also want to print with ironing on top layer for a nicer finish.
  • No supports needed, just print flat on the bottom.

Tagi