Dice Tower - Dragon's Keep
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix for dragon dice tower to make it printable with practically no supports.
- Ocena
- 5 / 5
- Polubienia
- 215
- Pobrania
- 1090
- Wydruki
- 8
- Wyświetlenia
- 4842
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Share Alike
Only .08gram of Supports needed(For teeth)!
I've been eyeing this model for a while. I really wanted to have a dice tower with a dragon on it but the original model was slam full of supports as every spine on the dragon was pointed down and the dragon wasn't really connected to the tower much at all. I readjusted all spines to point upward, angled head/neck up, gave him a tiny bit of battle damage on the wing, pushed the dragon around until is was connected at all lower points to the tower to totally remove the need for any supports on the dragon. Only the teeth need supports.