1 / 1
Ridgid R4514 Table Saw Zero Clearance Insert
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
For large enough printer, just use the body_full and the two nob parts.
For smaller printer, you will have to print the body as two parts and then connect them using 3 copies of the insert. Use glue if you want to make it permanently.
For both options, then follow the steps below:
- Put the nob_upper part through the hole at the bottom-right corner of the body plate
- Connect the nob_lower part from under the body plate. The fit is made quite tight on purpose. You may need to use a clamp to help push it in
- (Optional) Use a 1/2 inch screw to fasten the 2 nob parts