Heinz 73mm Tin Can Stacking Ring
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows the annoyingly non-stacking Heinz tin cans to stack efficiently and sturdily.
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 77
- Wydruki
- 3
- Wyświetlenia
- 310
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
PETG suggested for long-term durability but PLA (ideally +/Pro) will probably suffice. With PETG, I found the bridging over the bottom channel was a bit rough and it affected how well it fits on the rim of the tin can. Perhaps scaling up slightly in the Z direction would allow enough space for it not to matter.
PETG supports were very difficult to remove in such a narrow channel and resulted in some chewing up of the walls. Printing PETG with PLA supports on the Prusa XL (Soluble Full profile - no top gap) worked really well. This could presumably also be done on Bambu Lab printers with AMS units, but with considerably more filament waste and time.