1 / 4
Magnetic WyzeCam v2/3 Garage Door Mount — zdjęcie 1
1 / 4

Magnetic WyzeCam v2/3 Garage Door Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Magnetic WyzeCam v2/3 Garage Door Mount

Ocena
0 / 5
Polubienia
4
Pobrania
9
Wydruki
0
Wyświetlenia
231
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution

Magnetic WyzeCam v2/3 Garage Door Mount

This solution provides a method of mounting a WyzeCam2 to your garage door looking outside (or I guess you could turn the camera around as well).

Position on door so camera can see out of garage door window.

The slots on the side are for four magnets.

The magnets are craft magnets that can be purchased at many craft stores (I got mine at Harbor Freight for $0.99 for a pack of two). They measure 10x22x48mm. The holes have enough room for a little bit of play. Don't forget to pay attention to the polarity as you add the multiple magnets.

Print Settings

Supports: Yes

Resolution:  0.2

Infill: 15

Filament: Any PLA or PETG Any 

Notes: 

Parts need to be oriented correctly on the printbed.

Both the Garage-Door-WyzeCam v2/3 and the GDoor-Cable-Guide need to be positioned on their sides with the holes for the magnets facing straight up (no supports will be needed).

The Camera-Mount should be place upside-down (smaller square hole facing up) and then print with supports "Touching Buildplate".

Category: Camera

Tagi