1 / 3
MMU3 stand for on top of Lack enclosure — zdjęcie 1
1 / 3

MMU3 stand for on top of Lack enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Stand for on top of a Ikea Lack enclosure, with a 15% angle

Ocena
5 / 5
Polubienia
44
Pobrania
131
Wydruki
5
Wyświetlenia
1018
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Due to the lack of space in my ‘office’ / study, I have my MK4 in an Ikea Lack enclosure.
After upgrading to the MMU3, mounted on top of the MK4 and the buffers for the MMU3 on the side of the MK4 printer, I noticed that the space within the Lack enclosure was very tight.
After trying other settings and already designed parts, my conclusion was: This won't fit like I like it to fit.
Setup now is:
Lack enclosure used for the MK3 (https://www.printables.com/model/17-original-prusa-i3-mk3-enclosure-ikea-lack-table-pr)
Filamentguide for Lack (https://www.printables.com/model/200854-lack-table-filament-guide)
Because of the fact that the power/data cord of the MMU3 is not suited for putting the MMU3 on top of the lack, you have to raise the MK4 a few centimeters.
I have used the HULA dampers (https://www.printables.com/model/873633-hula-for-prusa-mk34-prusa-bear)
The buffers for the MMU3 are mounted with sidemount (https://www.printables.com/model/913403-removable-mmu3-buffer-side-mount) to the back side of the Lack table

And then finally the MMU3 on top of the Lack enclosure/table.

Print with PETG.
25% Grid infill
0.20 mm Structural 

Tagi