QMX Touch Key Mod Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a bracket that is used with the CW touching keying mod for the QMX radio.
Parts you will need
1) The K6ARK Capacitive touch PCB
2) 4-40 Pan head bolt, QTY 2 (Believe I used 5/16”) It was from this kit.
3) 4-40 Acron Nut, QTY 2, Pack of 10
4) 30 ga wire – I used multiple colors from this kit
5) Kapton tape. I had on hand but previous bought this kit.
6) VHB Tape to secure the board internally. I had on hand but previously purchased here.
7) A 3D-print of my touch key bracket (Recommend using PETG)
You will have to modify/cut your QMX case to perform install this part. Please my attached modification notes PDF