Jeep Wrangler Body For Trx4m

here is my jeep wrangler body for a trx4m. i print the main body and glue the details on how ever you want. it comes with the bumpers it needs to be put on a trx4m. it wont work on the normal bumpers. be sure to support the main body well the walls of the body are about 2.5mm thick so there's some rigidity but while printing the walls may wobble with out acquit support. personally i printed the detail parts (hinges, lights and vent) on a resin printer for better looks and not wanting to sand that much. 

Mounting to trx4m:

so since the body is not super easy to align with the wheelbase considering how short the front end would have to be, i designed a new front bumper. This front bumper replaces both the trx4m front bumper and the front piece that braces the front rail and secures to the body clip.  the rear bumper is a direct replacement for the normal bumper. the main body has a ridge that slides into the front bumper that acts as a sort of hook. the back of the main body has a square cut out. this is where you glue in the rear clip which mimics the clip on the original body. 

to install the body install the front bumper and rear bumper using the original screws. then hook the front of the body on the front bumper. the tooth on the front of the body will slide into the slot on the front bumper. then push back down so the clip snaps over the rear retainer as with the stock body.