1 / 6
Creality K1 MAX Unibody Riser W/Glass slider and filament sensor relocation — zdjęcie 1
1 / 6

Creality K1 MAX Unibody Riser W/Glass slider and filament sensor relocation

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Creality K1 / K1C Unibody Riser Remixed for K1 MAX

Ocena
4,5 / 5
Polubienia
121
Pobrania
634
Wydruki
3
Wyświetlenia
5082
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Few people have said that the fit is snug, I would suggest scaling everything to 102% should make it a bit less snug. 

Currently i'm working 72hr weeks and don't have the time to get around to fixing this. 

DISCLAIMER: You will have to trim off some of the tabs on the plates depending on orientation as there is interference with the corner brackets to glue the beams to.  
Please pay attention to this. 
Since plates are split into 2 parts and universal I didn't want to upload multiple plate files as it's easy to cut off 1 tab depending on orientation. The sensor plate already has the tab removed for you because it's not universal. 

Glue together the beams to the corners and then print the plates and slot them in. 
fill, sand, prime and paint if desired. 
slide in glass and then press fit corners of whole assembly into printers top, whole assembly should be pretty rigid once assembled and locked in.

I printed the main frame upright this creates a lot of waste with supports but I found it gave me the cleanest result. orientation can be changed to best suit your needs. upside down would require the least amount of filament for supports but I was having issues with the overhangs coming out clean. 

I color matched the body of the riser as best as I could with a 10 year old can of dynamic cast iron grey spray paint I had, picture of can included in photos.

Added the obj file of the whole assembly incase you would like to remix or need to fix something.  

I'm not amazing at 3d modeling so I did my best, I managed to get the assembly working for me, though some sanding was required, I have since added a 0.2mm gap between some parts to give more tolerance. 

Print List:

Print 1x of each corner (FRONT RIGHT, FRONT LEFT, REAR LEFT, REAR RIGHT)
Print 1x REAR BEAM
Print 3x BEAM UNIVERSAL 
Print 3x PLATE LONG (UNIVERSAL)
Print 1x PLATE SMALL (SENSOR RELOCATE)
Print 1x PLATE LONG (FOR SENSOR RELOCATE SIDE)

IF USING LOGO PLATE
Print 2x PLATE SMALL (NO LOGO UNIVERSAL) 
Print 1x PLATE SMALL (LOGO UNIVERSAL)

IF NOT USING LOGO PLATE 
Print 3x PLATE SMALL (NO LOGO UNIVERSAL)

Tagi