Tenkara Fly Box V3

I've been trying to design the best compact all-in-one tenkara fly box. This is my latest iteration of that and it now my new goto fly box when I go Tenkara fishing! It holds everything I need. 

Do you not need a whole spool of tippet? Remove the tippet holder section and just use the fly box and line holder. This is my default configuration. Additionally, you can use the magnets on the underside of the box to hold the lid when you are trying to pick your fly. Then, you can even use the magnets on either side to help hold the fly as you get your tippet ready. 

Hardware Required: 
6 5x2 magnets 

3 20x2 Magnets(If you print the base with magnets)

2 M3 nuts

1 M3x10 Screw 

1 M3x14 Screw(You could get away with 2 M3x14 instead of 1 M3x10)

If you want foam, then

6mm craft foam sheet in black or white.

Minimal Config: 

1.

Other configs: 

2. 

3.

4.(Insanity) 

*You can just print the base and the lid if you want. 
Assembly instructions for minimal config: 

1. Print the the base(either with magnets or without), lid, and end line holder. 
2. Add the magnets to the 3 holes in each print. (The 20x2 magnets go in the base)
3. Add the m3 nuts to the middle of the base. 
4. Screw the base on top of the line holder. 
5. Cut the foam to about 5mm and insert it in the line holder section.
6. Fill with flies and tenkara line/tippet. 

Refer to the pictures above to ensure you put it together properly. Also, ensure you put the magnets in properly so that they work properly. 

Feel free to message me any questions! 

Additionally, this fly box is  inspired by two other fly boxes. They are the Ikari Zenit and the Ultimate Light Weight Bamboo Fly Box by Revus Designs on Etsy. The line holder is inspired by the line holder from Tenkara Rod Co. I highly recommend that everyone goes and checks them out if you haven't already!