Original Prusa Enclosure Led
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Led strip holder and diffuser to illuminate the Original Prusa Enclosure.
- Ocena
- 5 / 5
- Polubienia
- 38
- Pobrania
- 90
- Wydruki
- 3
- Wyświetlenia
- 1031
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of the led strip holder and diffuser project of @michelem.
I used the led strip holder and diffuser to illuminate the inside of the Original Enclosure with a USB 8mm led strip.
I add to the original project a more thick variant of the diffuser and a led strip holder that is used to attach the led strip to the frame of the enclosure with some M3x8 screw and nuts. The number of screw and nuts necessary depends on the length of the led strip that you want to use. Personally i used 13x M3x8 + 2x M3x14 (necessary only if you have the Enclosure hinged lid upgrade) screw and 15x M3 nuts to cover all the enclosure with the led strip.
For the long part of the enclosure you will need:
- 2x Led_base_250x8mm
- 2x Led_Diffuser_250x8mm
- 3x Led_StripHolder
- 3x M3x8mm screw+nuts
For the short part:
- 1x Led_base_250x8mm
- 1x Led_base_200x8mm
- 1x Led_Diffuser_250x8mm
- 1x Led_Diffuser_200x8mm
- 4x Led_StripHolder (you can also use 3x Led_StripHolder but if you want more stability i suggest to use 4x. You don't need to use screw and nut on the one that is used to add stability to the Led_base_200x8mm because it's keeped in place by the Led_base_250x8mm)
- 3x M3x8mm screw+nuts
For the part where the hinged lid is attached to the enclosure, just replace the 2x M3x8 with 2x M3x14 screw.