Camping Stove Fuel Canister Legs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tripod stand for fuel canister.
- Ocena
- 5 / 5
- Polubienia
- 26
- Pobrania
- 120
- Wydruki
- 1
- Wyświetlenia
- 1164
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
All of the stands like this that I've seen require a central piece for the legs to connect to. This design eliminates that by interconnecting the legs to each other. The legs create an 8" diameter base for more stability. They could be redesigned to be longer if needed.
The .STL file is for 1 leg. You must print 3 of them.
The hooks that clip to the bottom rim of the canister are very tight. It takes some force to snap in, and some work to pull them off. But they might wear down with use. I have only tested a larger 4.25" diameter canister and it fits just right. I have not tried a smaller 3.5" diameter so not absolutely certain the inner hooks are in the correct place.
Category: Outdoor & Garden
***UPDATED 7/22/25
The original file was designed with a “T” shaped profile. A new .STL file was added today with an “L” shaped profile. This removes the need for support. The two files are not interchangeable. Use one file or the other and print 3.
***UPDATED 7/23/25
I realized after printing the “L” profile that it needed a beveled cut on the bottom slot. Otherwise the 3 legs can't slide into each other. I broke one in the process. So I've replace the .STL file with and updated one.