Bambu Poop Chute with slide out tray for Hula Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified John Hamill V2 files to use with Voxel Hula anti-vibration feet
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 735
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update: 7/16/24: After creating and installing a taller version, I discovered that the slide had sufficient layer steps to impede the poop from sliding freely. I used 80 grit, 120 grit and 320 grit sandpaper to remove the roughness of the steps. The poop is now very happy with the slide.
After recently installing the Voxel Hula Anti-vibration feet to my new P1S, I realized that the original chute by John Hamill would not quite work. To clear the Hula foot, the base needed to be taller, which also allowed for a deeper drawer.
Using Fusion (I am learning), I imported the mesh file, turned it into a solid then combined the triangles on some of the flat surfaces, then made the following changes:
- Added 9 mm depth to chute base
- Extended the walls of the chute drawer opening 10mm higher.
- Added 10 mm to drawer depth. I did not change the deflector ramp in the back of the drawer.
Added a recess in the drawer base 23mm tall by 65 mm wide by 5.5mm deep to clear the left-rear Hula anti-vibration foot. The Hula feet are 22mm tall. The extra mm allowed a small chamfer to add a bit of thickness in the drawer guide at the top of the recess. - Hollowed out the now taller drawer base by the 9mm I added, leaving the drawer base floor 3mm thick, as was the original.
- In addition to the changes for the Hula foot, I widened the opening at the top of the chute to uncover the portion of the rear panel ventilation that the original design covered.
I printed the chute with Atomic PLA in Deep Black and the Drawer and Lid in Atomic PETG in Gun Metal Gray, both of which are close to the colors of the P1S. My first attempt at the slide was also in the PETG but I temporarily forgot the carpenter's first rule: Measure twice, cut once. I put the recess for the foot in the wrong place. I then didn't have enough filament on the spool to print the chute again, so my chute is two-tone.
I used the stock lid and handle. I did not print the shroud, as the bin is tucked under the corner of my computer monitor.
Also, I should have done a little cleanup before I took the photos.
Thanks, John Hamill, for a great chute design. I hope others can use or improve the mods I made.