Q Acoustics QA 3030i speaker stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Universal stand for Q Acoustics speakers that you can adjust by cutting 25mm pipes to any required height.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 298
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Public Domain
I used 25mm diameter PVC pipe for cables as the legs. For the base I got a 20x30cm mdf shelfs to make the base mode sturdy and bottom heavy to avoid toppling.
Bracket is designed to fit to the speaker and to be screwed in using m8 srews to the threds available on the bottom of the speakers. I used Ikea Besta legs as those fit and I had plenty lying around. To sreak this is you have to remove original legs - those are just nailed in. Use something sharp to get very close to the pin center when removing to avoid damaging the rubber.
The top bracket I printed on the side. It needed a lot of postprocessing and grinding.
In the original the pipes were locking very hard.
The legs bottom I screwed into the shelf with wood screws. Printing the model in 101% scale allows to have less tighter fit.After assembly with 100% and 101% scale the stand holds when picked up without glueing or srewing the pipes in.
I considered making 25mm holes in the shelf instead of printing the bottom sleaves for the pipes but I decided this is a more flexible solution in case of future modifications.
It would be nice to make holes in the pvc pipe to thread the speaker cables through. I just taped them in mine.
To make 2 speaker stands it requires:
- 2 25mm diameter 2.5m pvc pipes (depends on the target speaker height)
- 4 printed top brackets
- 4 m8 screws for the speaker mount
- 8 wood screws
- 8 leg bottoms
- 2 20x30cm mdf shelfs (I cut 60x20cm one is half).