1 / 4
2-in-1 Case and Stand for ZSUS 2160*1440 14-inch 2K Portable Monitor
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case that doubles as a tall stand for a cheap portable monitor
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 1970
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (16)Powiązane
This model can be considered a first prototype of the idea. Although it works well in practice, there are a couple things that can be improved:
- I printed the model in the same orientation as it would stand, but the print quality at the top near the opening suffers since it is essentially a tall thin unsupported wall. It may be better to print in the orientation of the STL and use supports.
- The angle should probably be more vertical, currently it is 75 degrees.
- The case holds together decently due to the alignment features, but a positive lock would be nicer.
- The case takes around 500g in PLA, which seems too much. Should experiment with thinner walls, maybe also ABS/ASA which is less dense. Warping would be an issue (it already noticable with PLA).