1 / 3
Wall mount for aluminum blast gate, 4 inch gates (~100mm)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mount for Powertec and similar 4 inch (~100mm) aluminum dust collection blast gates.
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 683
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 2)Remiksy (0)Kolekcje (26)Powiązane
I recently replaced my plastic 4" (~100mm) blast gates with cast aluminum gates from Powertec, and I needed wall mounts for a few.
The blast gates I used are just under 11mm in the slot, and the 3 bolt holes are 77.5mm apart.
Included gcode uses PETG, since PLA gets a little soft in the sun.
Note: The blast gates leaked a lot when I first bought them. If you purchase the same ones, read the tips in the product page comments about filing down the interior manufacturing marks that are causing the leakage.