Antenna Pole Adaptor for Spirit of Air Wheel Mount Tube
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Internal Reducer for a Spirit of Air wheel mount tube
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 118
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Spirit of Air Wheel Mount is a great product, fairly sturdy however it does have one issue when used with a thin fibreglass antenna, that is the internal diamater of the Wheel Mount tube is massive, and the fibreglass sotabeam pole isn't. This means you do get a lot of rattling around, even if it is guyed down. As you ca see by this:

This make is desgned to reduce the internal diamater of the tube so that the fibreglass post fits more snuggly, although not too tightly, so there is still some movement. This was required to aid installation.
There are two parts to this:
- Base - this is inserted into the base of the Spirit of Air tube (the threaded end)

- End Cap - this goes in the other end. There are two sizes, small and standard. It is up to you which you prefer.

If you feel your antenna needs a bit more support you could print out one or more base sections as required.
So far I have tested this with PLA and ABS and both seem fine, however I do wonder if TPU would act as and extra damper.