Red Herring Spacer and Mag Release
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An extended butt stock and paddle magazine release lever for the Red Herring nerf blaster by Taffy!
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 24
- Wydruki
- 1
- Wyświetlenia
- 409
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a fairly simple remix that adds an extended butt stock to the Red Herring and makes the magazine release lever easier to reach. Field tested and solid!
The Butt Spacers require the following hardware:
- 2x screws, #6 x 3/4", countersunk
- 2x screws, #6 x 1", countersunk
- 2x screws, #6 x 2", countersunk
The hardware is installed at the locations in the screenshot. Four of the Red Herring's screw holes are reused for this remix, pictured in the next screenshot. These holes may need to be drilled to #6 size, but it may also be possible to drive the screws in by hand. Be sure to use tapping technique when driving the screws - 2 turns in, then half a turn out.
The Mag Release requires no special hardware and installs as normal.
I recommend printing all parts with at least 3 or 4 walls and high infill.