1 / 3
Suzuki Jimny JB43 strain relief for switch assy 4WD — zdjęcie 1
1 / 3

Suzuki Jimny JB43 strain relief for switch assy 4WD

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A strain relief designed for the Suzuki Jimny JB43 switch assy 4WD, part no 37680-76J01

Ocena
0 / 5
Polubienia
0
Pobrania
35
Wydruki
0
Wyświetlenia
561
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial

The JB43 Suzuki Jimny has a switch in the 4x4 system, part no 37680-76J01.

The switch itself is fine, but the design of the wires is quite poor: no strain relief (wires enter the switch directly and are only secured with a drop of resin) and no protection (wires are easy to tangle if crossing branches/rocks).

I've designed this strain relief to slide over the 21 mm nut (after installing it). Pass the wire through the channel (add a piece of rubber if wanted), then secure with two zip ties. The “scissor” action of the strain relief should keep it reasonably tight over the nut as well.

There are two variants: 

  • one at 21 mm, which will be very tight (the two “arms” will be apart)
  • one at 21.2 mm, which will be just fine (the two “arms” will be almost parallel) 

Prints with no supports, 4 walls for 0.4 nozzle, 40% infill. Obviously, use a tough material since it'll be exposed to heat, shocks and so on (ABS, ASA, etc).

 

Tagi