E-Dope Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Foldable holder for the E-Dope by DRS. Can be mounted onto a scope tube (25.4mm, 30mm, 34mm).
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 176
- Wydruki
- 0
- Wyświetlenia
- 1031
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The holder is designed for E-Dope by DRS, inspired (not a remix) by the DOPE Card Holder V3 by Tarz
E-Dope is retained in the holder by three flaps. A 1 mm wall on the top side prevents E-Dope from sliding out, but the holder flexes just enough to release the E-Dope when it's pulled up purposefully. A thumbhole at the top helps with that.
Printed in Prusament Prusa Galaxy Black PETG with 30% infill.
Required hardware
- 2 x M4 12mm Button Head Socket Cap Screw (like these)
- 1 x M4 16mm Button Head Socket Cap Screw (like these)
- 3 x M4 Nut (like these)
Assembly is straight forward.
Two M4 nuts go into the bottom half-ring, two M4 12mm screws go screw two half-rings together.
Make sure to fully tighten the screw on the side where the E-Dope card will be mounted first. Then adjusts the tightness of the ring using the screw on the opposite side.
Use the remaining M4 nut and M4 15mm screw to attach the E-Dope card to the clamp's “ears”.