Toilet Paper Protector (Mk6)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Toilet Paper Protector, to encase your TP roll so cats can't waste your precious stock pile (if you didn't hoard)
- Ocena
- 5 / 5
- Polubienia
- 27
- Pobrania
- 469
- Wydruki
- 1
- Wyświetlenia
- 2715
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Share Alike
I've done a few versions of this, hence the Mk6.
My cat has a tendency to see a toilet paper roll, decide it's a good snack, and take a couple bites out of it. So, I built the TP Protector Mk1. It was iterated on a few times, and recently I decided to start learning OpenSCAD so I made a newer model.
The issue I've had in the past is that different manufacturers make their rolls at different diameters, namely the new “mega roll” thing, and when I moved the TP holder wasn't as spacious. The OpenSCAD is designed so you can get it dialed in for your rolls. The STL's included are sized for what I've landed on as a “standard” mega roll, but you may want to measure your rolls and confirm against the OpenSCAD variables if it'll fit.
There are 2 “sticks” out of the shell to help stop the whole thing from spinning unnecessarily. When paired with https://www.prusaprinters.org/prints/24542-toilet-paper-roll-extender it should fit well on most “standard” TP holders.