1 / 11
Orbiter Filament Sensor (Roller switch) — zdjęcie 1
1 / 11

Orbiter Filament Sensor (Roller switch)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is my take on a filament sensor directely mounted on the Orbiter using a simple switch. The fit of the switch is…

Ocena
0 / 5
Polubienia
16
Pobrania
92
Wydruki
0
Wyświetlenia
1361
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is my take on a filament sensor directely mounted on the Orbiter using a simple switch.

The fit of the switch is quite tight to keep it from moving around.
Has been working flawlessly so far.
If the trigger point is off slightly, try bending the switch lever slightly in the desired direction.

Decide on your desired wiring based on preference and available board connections. ( e.g. pull-up/pull-down resistor, LED, 2 lead or 3 lead connection).

If you chose to use 2 leads only, an LED is not possible. Use a JST XH2P Connector and print the corresponding files.

If you chose to use 3 leads, use a JST XH3P Connector and print the corresponding files.

Print Settings

Printer:

V-Core 3

 

Rafts: 

No

Supports:

No

Resolution: 

0.2

Infill:

18 - 25 %

 

Post-Printing

Assembly

Insert the pre-wired components to the designated slots.

Close the lid and fix with M3 bolts.

Wire up the sensor to the mainboard.

Enjoy.

 

Tagi