MosSoaker - Sphagnum Moss Pole Water-Dripper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Place this on top of your stackable sphagnum moss pole, fill it with water, and it will thoroughly soak your moss!
- Ocena
- 3 / 5
- Polubienia
- 40
- Pobrania
- 230
- Wydruki
- 2
- Wyświetlenia
- 2633
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
A simple water dripper for a stackable sphagnum moss pole. Sits in the inner diameter of the stacking part of the pole. Uses a series of small funnels to slowly feed water onto the top of the moss, which IDEALLY should allow the water to slowly run down and soak the entire moss volume, and the remaining water will soak into the soil below.
Obviously your mileage may vary.
Diameter of the printed part's support pole is ~14.7mm, to fit the 15mm hole.
Let me know if you would like any changes/different sizes, or feel free to remix!
Why?
I always made a mess trying to slowly pour water onto the moss pole with a watering can or using a spray bottle to try to soak the outer surface of the moss pole.
My print details
- Solid PLA, whether you want infill to be 100% or use enough walls to make the print solid).
- I recommend using a stronger, more sun/heat resistant material like PETG, ABS.
- I printed upright and used tree supports, although it could certainly be printed upside-down, but that too would require supports.
Moss pole from Etsy here, not my store, not affiliated with me https://www.etsy.com/listing/939401116/16-30-38-handmade-stackable-sphagnum?show_sold_out_detail=1&ref=nla_listing_details)