HueForge Stained Glass Butterfly 2

I used HueForge Lithophane Blending Mode and an AI created image to make this second “stained glass" butterfly in a series in TWO parts.  The first part has just the blues (and greens) and black of the foreground. The second part blanks out the blues (but not the greens) and provides the reds and yellows for the background.  Both parts have very thin base layers, so special care is needed to remove them from the print bed. It is probably best to cool them completely before trying.

When joining the two parts be sparing with the adhesive, especially in the lighter parts. The adhesive will change the colors if it is not behind the darkest parts. I just used some around the darker parts and around the edges to keep the glue from showing. If spread thin and uniformly, it should not show too much.

Project: Butterfly2_Part_1.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150x154.97mm in size
You may print at higher layer heights below the Min Depth of 0.16mm
The Max Depth is 1.2mm and the Actual Depth is 1.2mm

Filaments Used:
PLA PolyLite Natural Transmission Distance: > 20
PLA Duramic3D White Transmission Distance: 4
PLA PolyLite Aqua Blue Transmission Distance: 3.5
PLA Overture Blue Transmission Distance: 4.2
PLA PolyLite Black Transmission Distance: 0.3
This print uses 5 unique filaments

Swap Instructions:
Start with Natural
At layer #2 (0.24mm) swap to White
At layer #4 (0.4mm) swap to Aqua Blue
At layer #6 (0.56mm) swap to Blue
At layer #11 (0.96mm) swap to Black for the rest.

Part 2

Project: Butterfly2_Part_2.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150x154.97mm in size

You may print at higher layer heights below the Min Depth of 0.16mm
The Max Depth is 1.2mm and the Actual Depth is 1.2mm

Filaments Used:
    PLA PolyLite Natural Transmission Distance: 35
    PLA PolyLite Lemon Yellow Transmission Distance: 6.5
    PLA Overture Red Transmission Distance: 4.8
    PLA PolyTerra Army Red Transmission Distance: 0.3
This print uses 4 unique filaments

Swap Instructions:
    Start with Natural
    At layer #2 (0.24mm) swap to Lemon Yellow
    At layer #5 (0.48mm) swap to Red
    At layer #10 (0.88mm) swap to Army Red for the rest.

If substituting filaments, pick ones with the closest TD values. Use a Natural white, if possible. Otherwise, pick the one with a TD > 10 to minimize the color change it will cause.