Beacon3D RevH Mount for Creality CR-10 Mini, CR-10, Ender 3

Mount to install a Beacon3D RevH on a stock Creality CR-10 Mini print head. Should also for fit older CR-10s and Ender 3s.

Beacon offsets for this mount:

[beacon]
x_offset: 0.0
y_offset: 16.0

Print Settings

• Rafts: No
• Supports: No
• Layer Height: 0.3
• Infill: 20%
• Filament material: PCTG

Designed to be printed in PCTG with a 0.6mm nozzle, but PLA and/or a 0.4mm nozzle should work as well.
Might be a little tougher to slot the Beacon3D in when using PLA as it is less flexible.

Installation

1. Push the Beacon3D into the slot. Make sure it sits straight and the screw hole is at the right spot. If it does not fit properly, the slot needs to be cleaned out using a knife or other tools until it does.
2. Fixate the Beacon3D with one of the screws that shipped with it.
3. Loosen the x-axis belt adjuster, remove the belt buckle on both sides of the print head and remove the lower v-wheel.
4. Push the mount onto the print head from behind. The tip of the Beacon3D should point to the front. It should be a tight fit, so no additional fastening is required (no screws, no glue, ...).
5. Re-install the lower v-wheel and the belt. Tighten the belt to about 25Nm.
6. Plug in the USB cable to the Beacon3D.