Film dryer (135, 120, sheet film)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
small dryer for film, using a 50W heater element
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 59
- Wydruki
- 1
- Wyświetlenia
- 904
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Dryer for various film formats (135, 120, sheet film). It uses a 120mm standard fan (12V) and a 50W 12V PTC heating element and a W1209WK digital thermostat.
You also need a simple shower curtain, M3 screws, nuts and threaded rods, aluminium rods (6mm) to hang on the film clamps, velcro tape and magnetic tape.
CAUTION !!!
Be sure that you use a proper power supply that is strong enough to deal with the 50W heating element. 6A / 72W or stronger should be fine but don't go below.
It says 5A in the drawing but I would rather suggest 6A to have some headroom for safety reasons.
Also the wiring must be strong enough. Only use AWG18 / 0.8mm² or thicker .
Unfortunately, the heater element I used isn't available at the moment. I'm searching for an alternative at the moment, also with more power.
PTC heater:
https://www.aliexpress.com/item/32699398441.html
thermostat:
https://www.aliexpress.com/item/1005005611120121.html
The fan I used (1000rpm) seems to be a bit week. I will try to replace it with a stronger modell and will report if that works better.
Cut the shower curtain to your desired length. I folded it over the magnetic tape strips and welded it together using a soldering iron. Put a piece of baking paper between the shower curtain and the soldering iron to weld them together.
The soft side of the velcro tape is glued to the shower curtain and the botom filter.
As filter material I used stuff from vacuum cleaner filters. Any other stuff that isn't to dense will work, I guess.