Keyhole Shelving Unit Joining Brace
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Brace to join vertical sections of a keyhole shelving unit
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 754
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I bought a “Pinnacle” brand shelving unit from Bunnings, The vertical posts are half height and joined in the middle. One shelf is meant to be in a fixed position to strengthen the join. Unfortunately I did not want a shelf in that exact position. So I only attached horizontal pieces on 3 sides. The front side was weaker than I'd like, so I designed these braces for extra support on the missing side.
It should be possible to use this on all 4 posts if you are short on the horizontal pieces. There is a 45 degree chamfer on all pieces to make it look thinner from viewable angles, and to allow them to fit if you need two braces on a single post.
Simple 2 part brace, joined with Nuts & M5 Bolts (12-16mm). I've chosen to use bolts as they will be the most secure and I want these shelves to handle plenty of weight.
Note: there are 4 different pieces for front & back, left & right. (Left from your point of view, looking at the shelves from the front)
I've used sparkle ABS for the front plates to give a similar look to the original frame.
Designed in OnShape if you would like to make changes