Aztek 3000S Airbrush Case insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement/upgraded insert to hold cups/tips etc for the plastic case of the Testors A3000S airbrush kit
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 646
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
The airbrush kit I bought had the worst foam and plastic insert, with an otherwise well thought-out case.
I drew this insert to hold all of the parts that come with the kit, which previously didn't fit in the space provided.
Printed at 15% infill in PETG, no supports required
This should printe equally well in PLA or ABS, and I also printed a resin version when I was test-fitting it (and my FDM was busy) and it worked just fine.
I hollowed a lot of the body out to make it look cool, and also to let the cups/tips etc dry out better if they are put away while wet
I also cut a little section of the case away at the back so I didn't have to wind the airhose up and stuff it away each time, that little half-circle you can see on the original case but the one on the other end.
:)