1 / 10
Galadriels sword - The Rings of Power — zdjęcie 1
1 / 10

Galadriels sword - The Rings of Power

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The sword seen on Galadriel's back in the promo poster for The Rings of Power.

Ocena
0 / 5
Polubienia
19
Pobrania
60
Wydruki
0
Wyświetlenia
444
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Props
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Model of the sword seen on Galadriel's back in promotional poster, modelled after a design sketch from WETA Workshop (https://www.artstation.com/artwork/xD24Pr). This is the version with the broken blade. The plan is to add a full length blade in the future (total length of that version will be over 1200mm).

There a two 3mm channels for adding carbon or steel rods for additional strength in the model. The cross guard should have a gem stone in the circular cutout at the top. In some sketches there are also three smaller gems on the centre point of the cross guard…

This is a bit of a theoretical post as i haven't done any test-prints yet…

The parts might need to be split into pieces to fit onto your printers bed. The cross guard can be printed standing but will require support in that case, all other parts should be able to print standing without support.

Update:

Finally had the time to test-print! Added some more pictures of the prints…the details can be a little bit hard to see in all the white filament.

Added a coiled grip model, not completely satisfied with the ‘raw’ model, but if you're going to wrap the grip with leather it's ok.

Tagi