Filament Cutter for Orbiter V2.0 on Dragon Burner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a Filament Cutter for the Orbiter V2.0 extruder mounted on the Dragon Burner toolhead.
- Ocena
- 4,333 / 5
- Polubienia
- 142
- Pobrania
- 524
- Wydruki
- 2
- Wyświetlenia
- 5741
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v2.0
This is a Filament Cutter for the Orbiter V2.0 extruder mounted on the Dragon Burner toolhead. However, it could technically be used on toolheads that have the extruder mounted on the top.
Parts are in the prefered orientation already. No supports needed. The distance from the pivot point to the cutting point, and the lenght of the Lever allows for the force required to cut the filament to be reduced about 6 times. Cutting action needs to be performed diagonally.
BOM:
- One of each of the Printed Parts
- One 5mmx30mm compression spring
- Two M3x25 SHCS screws
- #11 X-Acto knife blade
- Super glue
You need to super glue the #11 X-Acto Knife Blade into the Lever Bottom.stl. Then super glue the Lever Top.stl onto the Lever Bottom.stl with the blade.
It is recommended to clean the filament holes on the Case parts (Case Top.stl and Case Bottom.stl) using a drill bit.
Print using standard Voron parts recommendations.