Authentic Fallout Shelter Sign Hueforge

This is a Hueforge print of an original Civil Defense fallout shelter sign. I scanned my sign, posterized it to reduce it to 3 colors, and then processed it through Hueforge. This is a really easy piece to print, as it only requires 3 colors (Black, orange, and yellow). Since this sign doesn't really take advantage of any special color blending, I sliced it with an 0.16 first layer and a 2mm layer height. I did end up removing the line of text at the bottom of the original sign, because it was too small to be legible at any size. See the 2nd picture for an example of the original sign.

I have provided 3 different sizes of sign, with total heights of 150mm, 200mm, and 300mm. I kept the mounting holes used by the original sign, so it should be easy to mount on the wall with tacks.  You may need to slightly enlarge the holes on the 150mm sign, as they are tiny. The 150mm sign prints very cleanly, but the larger 200mm and 300mm signs show more of the surface dirt from the original.

Print at 100% infill with a layer height of 0.2mm with a base layer of 0.16mm

You may print at higher layer heights below the Min Depth of 0.56mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm
 

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 6
This print uses 3 unique filaments

Swap Instructions:
Start with Black
At layer #4 (0.76mm) swap to Orange
At layer #9 (1.76mm) swap to Yellow for the rest.