Holster for Sony RX100 M7 with belt clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A holster to have the Sony RX100M7 compact camera always ready too shoot. Inclusive cover
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 330
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update 2024-08-13: I used the holster printed in PETG during my vacation. It worked fine. For all security I did connect the wrist loop to a belt loop on my jeans with a carabiner. Better safe then sorry, but the camera never came out by itself, nor did I loose the holster or did the clip deform. (only be careful when you go to the bathroom… ;-) )
The TPU version with a belt loop (see my next remix) still has to pass the reality test. If you made it and have used it, please share your experience.
Update 2024-07-29: The version in TPU shows deformation in the clip after wearing. So far it still held up. However I recommend to print it in PETG for strength, and then add some soft padding. The soft part of velcro works perfect as padding when you stick it under the rim.
I will publish a special version for TPU with a belt loop instead of a clip.
I liked the design from @roel.gerrits of his holster for the Sony RX100 compact camera.
His way of attaching to a backpack did not fulfil my needs. I prefer a clip so I could hang it from my belt. Attaching it to your backpack straps has the risk that the camera will slide out, and/or get damaged when you take your backpack off.
Also I added a simple “emergency” cover that you can put on in case of rain. (or dust). You can also use it to protect your camera when it is inside your bag.
It is simple, it just slips over it. I avoided to design hinges, because they are always in the way. The disadvantage is that the cover is now a “loose” article. Anyhow it is best during rain to put on a coat and insure that your camera is under your coat,
I printed the whole design in TPU, to prevent scratches on the camera, The holster is then not so rigid…. You have to experiment a bit with the infill to get the required rigidity, especially for the clip. I used 100% infill.
Some supports are needed. See the 3mf files for info. When you use the 3mf files likely you have to change the material. I have fine-tuned the material settings for the brand (Purefil of Switzerland) of TPU I use.
Printing with PETG is imo possible, you likely have to add some protective padding to prevent scratches on your camera. I would not recommend printing in PLA because of its brittleness.
I added the gcode and 3mf files for PETG.
Be careful,
I will NOT be liable when your expensive camera falls to the floor and gets damaged!
Test before you use!
When you print it please give feedback.