Zuru inlineclip and plungerupgrade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The inlineclip holds six full lenght darts, you may need to modify the blaster slightly, in order to install the parts.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 430
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This inlineclip is fully 3d printable. Sadly it only works reliable with full lenght darts. I´ve tried fixing that, but couldn´t get it to work reliable eventhough I made half a dozen different prototypes. If you use half lengh darts it will sometimes fire two darts instead of one.
The tip of the muzzle may need some slight sanding in order to fit inside the barrel.
Print inlineclip muzzle and inlineclip main if you don´t have suitable 16x1 mm pipe. Print 16 back and 16 front if you do. (16 back and 16 front may be untested.)
USE A BRIM FOR THE INLINECLIP PARTS!
You´ll need 2 M3 flat head screws for the plungerhead. This upgrade isn´t neccessary, but I would recommend it for higher spring loads.
7.11.2021: I´ve added a second version to be used with 16mm x 1mm pipe