Collapsible Wolverine Claws
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
No “Vase Mode” needed ! This is a simple version of Wolverine Collapsible Claws !
- Ocena
- 5 / 5
- Polubienia
- 346
- Pobrania
- 936
- Wydruki
- 1
- Wyświetlenia
- 10 558
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have designed this version inspired by swords and other retractable models.
I have noticed that depending on the filament the performance may vary. For example with PLA+ from Sunlu I have better results than with CosPLA from Polymaker.
I recommend you to make some tests and do not hesitate to comment in order to improve this design.
Enjoy !
Intructions
I recommend printing a part to test the filament.
I recommend using only “strong glue” for the parts. Hot glue can cause problems with the “REAR” part.
Then follow the steps of the image
- Glue either the toe part or the back part (for the back part you will have to extend the whole claw).
- Finally align the first claw and glue it to the base of the hand.
Here is a video of me using them 👇