Dice Holder Dagger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A dagger with a hollow handle to carry a set of D&D dice.
- Ocena
- 0 / 5
- Polubienia
- 33
- Pobrania
- 138
- Wydruki
- 0
- Wyświetlenia
- 858
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Miniature Gaming Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a dice carrier that doubles as a dagger (a big dagger, almost a small sword). The handle slides into the blade/cross guard half.
The handle is 6.3" and the blade is 8.5". The overall length of the assembled dagger is 14.575".
The handle is a longer than it needs to be for a full D&D set. When you slice it, you could remove up to 0.5" for a more tight fit.
In Dice Handle 2.2, I have four triangles so I could print it upright. I printed the blade upright as well, both on 0.1 layer height and 60 mm/s. Then I cut off the triangles and wrapped the handle in electrical tape.
Dice Handle 2.1 has no triangles and can be printed in any orientation.