ZimaCube Fan Grill
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Custom ZimaCube fan grill for those who have upgraded their hard drive cooling fans to thicker fans.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 72
- Wydruki
- 1
- Wyświetlenia
- 673
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
This fan grill was made to be easily printed laying flat, no supports needed. It is fixed onto the back of the ZimaCube using 5x 8x3mm magnets (my magnets I ordered actually measured 8x2.6mm). The magnets should be pressed fit, at least on mine they were. If they are loose on yours then use glue as required.
I may model up a test piece later on for those who want to check before printing.
The fan grill has an angled top but it can be flipped around so the square side is at the top for those who want a boxy looking grill. There is around 40mm of clearance inside the fan grill and should fit nearly any fan size with room to spare.