1 / 2
MapTattoo Holder With 1/4" Mount — zdjęcie 1
1 / 2

MapTattoo Holder With 1/4" Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Lightweight holder for the MapTattoo GPS with 1/4" mount (same as typical tripod screw)

Ocena
0 / 5
Polubienia
1
Pobrania
18
Wydruki
0
Wyświetlenia
167
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I wanted a way to mount my MapTattoo to a suction mount without having to permanently stick anything on the back of it, so I cooked up a simple little holder to wrap around it and give me a ¼" thread I could attach my mount to.  The goal was to obstruct the device as little as possible, so this leaves the screen, buttons, USB port and the opening for a lanyard open.

Assembly:

  1. Print one copy of each of the pieces.  I recommend using the STEP files if your slicer supports it, as they will be smaller and slightly higher quality.  
  2. Insert an M3x4mm heat set insert (5mm outer diameter) in each of the holes in the top right, top left, and bottom clamping pieces.
  3. Clear out the strands in the ¼" hole in the base with a knife or screwdriver.  I included a single layer's worth of solid space there to ensure the bridged over hex hole prints properly.
  4. Insert a standard ¼-20 nut in the hexagonal hole on the top of the base.  This should be a fairly tight press fit.
  5. Use M3x8 screws to attach the clamping pieces to the base.  I recommend putting the top two pieces on lightly, just screwed in enough to keep from falling out, then sliding the MapTattoo into place underneath them and then loosely screwing on the bottom piece.  Note that the back of the MapTattoo should face the side of the base with the hex nut in it.
  6. Very carefully tighten the screws.  This is designed to have about a half millimeter gap between the clamping components and the base when installed, so you have some room to adjust the tightness.  It would be easy to put excessive pressure on the device with a hex wrench, so I tighten them down just until I start to feel resistance and then stop.  You only need enough pressure to keep the device in place.
  7. Now you can screw your mount of choice into the ¼-20 threads on the hex nut.  It should be deep enough to bottom out most tripod style mounts, but it doesn't hurt to double check before installing the MapTattoo to make sure your mounting screw doesn't protrude through the bottom and cause any damage.

Notes:

  1. Printed plastic can break, heat set inserts can pull out, screws can corrode, suction cups can get knocked loose.  Please don't make this the sole attachment of your device to your vessel, utilize the unobstructed hole on the bottom right to tether it as a backup to whatever other mounting option you use.
  2. If you're going to take this out into salt water you'll want to use stainless steel fasteners, or even titanium if available.

I've included the FreeCAD file as well, so feel free to edit to your liking.  And a big thanks to MapTattoo for providing some models of the product that made the design work a lot easier

Tagi