1 / 1
"Ender 6 - HeVORT Remix - Z-Tilt" Z motor jig/bracket — zdjęcie 1

"Ender 6 - HeVORT Remix - Z-Tilt" Z motor jig/bracket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

https://cults3d.com/en/3d-model/various/ender-6-hevort-remix-z-tilt

Ocena
0 / 5
Polubienia
1
Pobrania
11
Wydruki
0
Wyświetlenia
148
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Cover photo: Red is MGN12 Linear rail, Green is BWI's bracket, and Blue is this part.

2 parts depending on your requirements, since BWI doesnt include such a part in his files (https://cults3d.com/en/3d-model/various/ender-6-hevort-remix-z-tilt).

I only needed a motor mount as i dont require the additional ~34mm Z height loss that using the 42-34 ender3 motors above the bottom panel consume.

Created a 2nd model that can be used as a drill guide if you wish to go with BWI's original intention with motors under the bottom plate.

Drill Jig template is “full height” of the motor mount model which will allow you to screw to the 4020 if desired. if this isnt required, simply cut/scale Z axis in your slicer to save on print time.

2x M3x10 & t-nut required, per bracket.

4x M3x12 & washers for nema17 motor, per bracket

Print settings:

2 peices required, flip over (or Mirror!) for the right side bracket.

i printed in ASA, 0.32mm layer, 5 walls, 55% infill.

Tagi