Reworked feet for Antikythera Mechanism
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A slight variant to the feet of the Antikythera Mechanism mode that makes it easier to install heat inserts.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 74
- Wydruki
- 0
- Wyświetlenia
- 247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
When I built the wonderful Antikythera Mechanism, I had some problem installing the heat inserts into the feet. My heat insert tool was too clunky and try as I might, I could not install the heat insert without melting the rib. You can see the resulting blemish in my photos above.
This remix has two different variants of the foot: one with a half-height rib, and one with no rib at all. These leave more clearance for your heat insert tool.
I used Prusaslicer and a negative volume to remove the ribs; the included .3mf files show what I did.
Good luck, and I'd love you see your prints!